THJ Series "spring-loaded hydraulic rail clamp"

THJ series "hydraulic rail clamp spring" is the use of spring tension, clamping the track to prevent the crane is a large wind run.  
• Spring clamp rail device works
 Connected to the mains, solenoid valves work to block the hole at the same time pumps work, the fuel tank filled with high-pressure oil, putting on the cylinder to promote rail clamp pliers, open the folder rail clamp. Calibration of hydraulic pressure to be the upper limit reached by the pump pressure switch cut off power to the crane to normal driving (Note: When the hydraulic pressure reaches the lower limit of calibration, the pressure switch connected to the power pump - fill pressure to ensure the rail clamp pliers The open). Cut off the mains, solenoid valves, opening the exhaust hole, the release of high pressure oil fuel tank, clip the elastic rail clamp with a spring clamp the track.
 • Spring clamp rail installation in the form
Flange mounting on：THJ-5T-F、THJ-10T-F、THJ-15T-F、THJ-25T-F、
　　　　　　                 THJ-30T-F、THJ-40T-F
Side flange：THJ-5T-C、THJ-1OT-C、THJ-15T-C、THJ-25T-C
Car installation：THJ-10T-Z、THJ-15T-Z、THJ-25T-Z、THJ-30T-Z、
　　　　　　        THJ-40T-Z
　　　　　　        THJ-40T-Z