QKZ series "ripping device "

QKZ "Automatic ripping device " is to prevent the 65m / s strong typhoon, the portal crane blown and developed equipment to prevent the crane tipping in the wind. It began its work in the crane, lift clamp automatically ripping, and higher than the orbital plane 25mm, when the crane to stop work, as long as the cut off the power, ripping both clamp down automatically, and can now automatically track the whereabouts and pay close attention after the Track.
 Caliper stuck track, ripping the grasping forceps device to automatically track the following concave trench caught and lose track, so that the card rail clamps and rail connections into one, such as the installation of four cranes ripping each device, Both to prevent the 65m / s strong typhoon crane blown the door. 

Features: ripping the driver can always control the device and let go, do not need a fixed point of parking. And in the special case of power failure, automatically seize the track, to resist uplift forces of 20 tons. (With manual troubleshooting operating system)  This product is suitable for standard rail QU70 type, orbit wide 70mm, as with other models orbit, to be declared in advance and provide orbital model and track sections. And called the orbital plane above ground level 60mm, such as the track surface parallel to the floor, the requested track on each side of 60mm wide and 50mm deep clear space to enable ripping to seize control of the concave groove track below.